Remeshing(网格重划分).ppt

Ways to improve the mesh in MSC.Marc Local Re-meshing Global Re-meshing Multipoint Constraint Equations 2-D 3-D un is displacement node n In order to obtain some “smoothness”, the difference between refinements levels of the neighboring elements will newer be larger than one: The one-level-rule will also be applied to elements for which no adaptive criterion has been activated. Increase of number of elements: It is important to chose the maximum number of refinement based on that ! Position of new nodes: By default, the position of newly created nodes is derived from the position of the master nodes: Improvements can be obtained by taking into account geometrical information, attach nodes to geometrical entities: Initial bad representation of geometry is not improved ! Position of new nodes (cont.): Attaching Newly Created Nodes: If the master nodes of an element edge have been attached to a geometrical entity, the newly created edge node will also be attached to this geometrical entity. If, in a 3-D analysis, all nodes of shell element 75 or all nodes of the face of a tet4 or a hex8 element have been attached to a geometrical entity, all newly created nodes corresponding to the shell element or the tet4 or hex8 face will be attached to this geometrical entity. If, in a 3-D analysis, the master nodes of an element edge have been attached to two geometrical entities, the newly created node will be positioned on the intersection of the geometrical entities. Position of new nodes (cont.): Example: Cylinder-cylinder intersection Initial FEM mesh ! Position of new nodes (cont.): FEM mesh after 3 refinement levels ! Position of new nodes (cont.): What to do at interfaces of elements with different refinement levels? In-plane displacement must be tied linearly Transverse displacement cannot be tied linearly and are left free All rotations are tied linearly Position of new nodes (cont.): General 3-D Situation: If nodes 1 and 2 are not attached to a sur