机械专业英语3-4.pptVIP

拓展词汇 Mechanical properties 机械性能 弹性 elasticity [?l?st?s?ti:] 塑性 plasticity [pl?st?s?t?] 刚度 rigidity 强度 strength 硬度 hardness 冲击韧性 impact toughness 疲劳强度 fatigue strength 断裂韧性 fracture toughness 103 :ten to the power of three. 7.39×106 :seven point three nine times ten to the power of six. 82600=8.26×10×10×10×10=8.26×104 This is an equation, which reads eighty-two thousand, six hundred equals eight point two six times ten, times ten, times ten, times ten equals eight point two six times ten to the power of four. 3×10-5: three times ten to the power of minus five. “+”plus “ – ” minus Four girls have a basket with four apples in it. How can you divide the apples so that each girl gets a whole apple and one still remains in the basket? Give three girls an apple each, and give the fourth girl her apple in the basket. A police saw a truck driver going the wrong down a one - way street, but paid no attention to him. Why? The truck driver was walking there All I want is a proper cup of coffee made in a proper copper coffee pot, you can believe it or not, but I just want a cup of coffee in a proper coffee pot. Tin coffee pots or iron coffee pots are of no use to me. If I can’t have a proper cup of coffee in a proper copper coffee pot, I’ll have a cup of tea! 6.3 Chemical Machining (CM) Chemical or electrochemical polishing where weak reagents are used (sometimes with remote electric assist) for polishing or deburring and chemical jet machining where a single chemically active jet is used. 采用弱化学试剂进行抛光和去毛刺的电化学抛光，以及利用单一化学活性喷射的化学喷射加工。 Because the etchant attacks the material in both vertical and horizontal directions, undercuts may develop (as shown by the areas under the edges of the maskant in Fig.6.2b). 由于蚀刻剂沿垂直和水平方向开始蚀除材料，钻蚀量会进一步加大，如图6.2b所示的保护层边缘下面的区域。 Unit6 Nontraditional Machining Processes 6.3 Chemical Machining (CM) Dimensional variations can occur because of size changes in artwork due to humidity and temperature. This variation can be minimize