NOVAJET 750写真机原版手册.pdfVIP

NovaJet 750 Printer Training Guide Training Guide Ink Installation Printer Calibrations Routine Maintenance Preventive Maintenance Cartridge Checklist Advanced Troubleshooting Print Server Networking NJ750 Training Guide A. Ink Installation 1. ‘Plug and Play Cartridge’ characteristics Installed needle assembly Do not break connection when installing new cartridge 25 ml inside - preprimed 2. Installing ink into reservoirs It is suggested to fill reservoirs over a table to prevent spills on printer; fill to a maximum of 400 ml (50 ml minimum). 3. Attach septum fitting to valve body. Prime line (and cartridge if necessary). NOTE: When the valve body is raised to the up position ink flow is cut off, when the valve body (latch) is closed then the ink line is open. 2 NJ750 Training Guide a) Prime line using the short needles (purple in color); attach short needle to each of the 4 valves. Connect septum needle to EasyPrime by inserting into female receiver. Depress and hold EasyPrime activation button to provide a solid burst, wait 20 seconds, or until ink line is full. b) Lift valve actuator (to up postion) and remove purple septum needle assembly. c) Connect cartridge’s septum needle to valve and close valve – wait 60 seconds then remove the blue tape from cartridge jet plate. NOTE: If attempting