世行《标准采购文件－工程及服务－基于道路合同》Oct－2006－en.docVIP

SAMPLE BIDDING DOCUMENTS Procurement of Works and Services under Output- and Performance-based Road Contracts and Sample Specifications The World Bank Washington, D.C. October 2006 October 2006 revision This revision dated October 2006 incorporates the following changes: Section I - Instructions to Bidders para. 16.1: ...requirement of works and completion times was replaced by ... requirments of Section VI, Specifications para. 29.3: Section VI, Works Requirements was replaced by Section VI, Specifications. Section III: Evaluation and Qualification Criteria (Following Prequalification): Under para. 2.2, missing CCC and FIN-1, were added. (Without Prequalification): Missing tables containing qualification and evaluation criteria, were added. Section VI Specifications The following paragraph, located towards the end of this section, was removed: It is nevertheless important to remember again that this sample bidding document should not be used for roads or road networks in very poor condition which require a substantial and costly upgrading and/or rehabilitation before they can be maintained. It is suggested that whenever the initial upgrading and/or rehabilitation or improvement works are estimated to cost more than 45 percent of the total contract amount, this sample bidding document should not be used. 2006 Output- and Performance-based Road Contracts Sample Bidding DocumentProcurement of Works and ServicesunderOutput- and Performance-based Road Contracts October 2006 These Sample Bidding Documents for Procurement of Works and Services under Output-and Performance-Based Road Contracts (OPRC)?have been issued by the World Bank on a trial basis to provide its clients with an alternative to the traditional methods of procuring road reconstruction, rehabilitation and maintenance. The documents are a further development of the earlier “Sample Bidding Documents for Procurement of Performance-based Management and Maintenance of Roads (PMMR)” which