Vertical vibration-assisted magnetic abrasive finishing and deburring for magnesium alloy文档.pdfVIP

International Journal of Machine Tools Manufacture 44 (2004) 1297–1303 /locate/ijmactool Vertical vibration-assisted magnetic abrasive finishing and deburring for magnesiu malloy Shaohui Yin a,, Takeo Shinmura b a Material Fabrication Laboratory, The Institute of Physical and Chemical Research (RIKEN), The Nexsys Corporation, 1-7-13 Kaga, Itabashi-ku, Tokyo 173-0003, Japan b Graduate School of Engineering, Utsunomiya University, 7-1-2 Yoto, Utsunomiya, Tochigi 321-8585, Japan Received 19 January 2004; received in revised for m9 March 2004; accepted 26 April 2004 Abstract The ultimate goal of this project is to develop an efficient finishing process enabling unskilled operators to finish automatically the complicated micro-curved surface and edge surface of the magnesiu malloy. The results achieved in the first phase as described in this paper focus on the basic characteristics of the plane and edge surface finishing and deburring of this alloy by the use of vertical vibration-assisted magnetic abrasive finishing process. It demonstrates that realization of efficient finishing of magnesiu malloy is possible by the process. The removal volume per unit time of magnesiu malloy is larger than that of other materials such as brass and stainless, that is, high-efficiency finishing could be achieved. Micro-burr of magnesiu malloy could be removed easily in a short time by the use of the magnetic abrasive finishing process. Furthermore, deburring efficiency consider- ably increases wi