GSM网络规划(english).docVIP

GSM NETWORK PLANING-SWITCHING GSM网络规划 张晓丹 This test consists of 17 questions. To answer choose on of the three alternatives and mark on the answering sheet. Pocket calculator and Erlang table is required How many traffic channels can maximum be handled by a TRX? A) 1 B) 4 C) 8 How many TS are required on the Abis interface per TRX if LAPD A) 2 B) 2,25 C) 3 How many TSs and E1s are required to connect the following access network to a BSC when a DXC is used to get maximum utilization of the E1s? Access network with 30 sites of type 3/3/3 and 20 sites of type 2/2/2. LAPD-multiplexing and LAPD-concentration is used. A) 870 TSs, 29 E1s B) 848 TSs, 28 E1s C) 780 TSs, 26 E1s How many TSs and E1 are required for traffic on the Aatr interface when the traffic to be supported is 710 Erlang and GoS =1% A) 738 TSs, 24 E1s B) 185 TSs, 6 E1s C) 683 TSs, 23 E1s Which type of routing is used for mobile to land traffic in the picture below? A) Near-end drop B) Cascading C) Far-end drop Is flat, meshed network architecture best used in small, large or medium networks? A) Small B) Medium C) Large How many physical connections are required in a network with 10 MSCs in a flat fully meshed network and in a hierarchical transit network with two transits? 100 (meshed), 10 (transit) 45 (meshed), 20 (transit) 100 (meshed), 20 (transit) Which of the following Signaling System No. 7 Protocols are used for routing of signaling messages? A) MAP, TCAP B) TCAP, SCCP C) MTP, SCP Which protocol performs the addressing for circuit related signaling? A) MTP B) SCCP C) ISUP What is the input and output information is GTT? input: GT, output: DPC input: B number, output: DPC input DPC, output: GT A link set has three signaling links, on which load sharing is used and the maximum load per signaling link is 30%. What will be the maximum signaling volume that can be carried on this link set? A) 192 kbit/s B