ADAMS实例教程08.pdfVIP

WORKSHOP 8 LIFT MECHANISM I Bucket Boom Shoulder Base Mount ADM701, Workshop 8, January 2012 Copyright 2012 MSC.Software Corporation WS8-1 ADM701, Workshop 8, January 2012 Copyright 2012 MSC.Software Corporation WS8-2 • Workshop Objective – Use Adams/View to create each moving part of the lift mechanism. – Optional – if you’d like a challenge, build this model without going through the detailed steps presented on the following slides. Use the dimensions shown on the next page to build the following parts of the model: • Create the base • Create the mount • Create the shoulder • Create the boom • Fillet the mount to round off the edges • Create the bucket • Chamfer the bottom edges of the bucket • Hollow out the bucket – Otherwise, continue by following the detailed instructions. • Software Version – Adams 2012 • Files Required – Use the directory exercise_dir/mod_08_lift_mech_1 ADM701, Workshop 8, January 2012 Copyright 2012 MSC.Software Corporation WS8-3 • Problem Description – Use the diagram and the properties shown below to help you build the lift mechanism. All units are in meters Bucket Boom Shoulder Base Mount ADM701, Workshop 8, January 2012 Copyright 2012 MSC.Software Corporation WS8-4 • Tips before you start – Check the three-dimensional view of the model at regular intervals to verify that the parts