LCD_Circuit汇总.pptVIP

2) Pixel Driving Method High voltage driving method and low voltage driving method among methods for driving unit pixel are described as follows. a) High Voltage Driving It is the method generally used for Dot Inversion and the same data line, that is, Output Channel of Column Drive IC drives positive and negative polarity respectively. Polarity is divided into positive polarity area of high voltage and negative polarity area of low voltage with Vcom of voltage. Then Column Drive IC drives with high voltage.Refer to Vcom section of Chart 1.14 and Gamma section of Chart 1.15. b) Low Voltage Driving It is the method generally used for Line Inversion and drives common electrode voltage and data permitted voltage to the opposite phase each other by AC. Refer to Vcom section of Chart 1.14 and Gamma section of Chart 1.15. 3) Panel Driving Method a) Analog Drive Method It is the method that directly uses analog voltage, which is the form video data entered, for liquid crystal driving voltage. The serial analog signals display all natural colors and simple circuit configuration is possible because just 3 signal lines are used. However, velocity is very slow (about 5MHz～20MHz) and Chip die is large, so it is too expensive to develop IC for compact OA and applicability is not so good. b) Digital Drive Method The form of video data entered is digital voltage and Column Drive IC passes the digital-to-analog converter in order to drive the panel. The number of colors which can be displayed depends on the number of digital bit. Now this method is generally applied and also has many problems including complexity and EMI. . World No 1 TFT-LCD LCM(Liquid Crystal Module) is composed of three blocks. The panel block has the lower glass that has formed TFT on surface, the upper glass that has under-formed color filter and LC is poured into a gap,and the seal. The circuit block has t