订书机针槽冲压模设计精选.docVIP

订书机针槽冲压模设计 关键字:级进模;排样;冲裁;弯曲;凸、凹模 Abstract In our daily life, stamping parts can be seen everywhere, such as metal washbasin, USB interface, nail clippers, clamps, etc, it with our life is closely linked, they are all manufactured by stamping mould. With the development of society, the shape of the stamping parts is becoming more and more complex, more and more small, the quality requirements are also more and more high, some in the traditional stamping process to mold order punching in small complex parts, more of the multi-position progressive die forming. There are molded into a mold level of good quality, high production efficiency, played an important role in stamping forming. This graduation design is to design the stamping mould of Mini stapler nail groove, as the part is small, material is thinner, its suitable to select the progressive die to forming the parts. In the mould design, at first do the layout design, and then determine the structure of the mould , on each station on the punch of concave modules specific design, and the necessary check, to other parts design, and finally to design machining process of the parts. According to this measure, the general calculation of side drawing, and gradually completed the design. Keywords: progressive die; layout; blanking; bending; cavity and core 目 录 第一章 绪论 1 1.1 级进模的含义 1 1.2 级进模的特点 1 1.3 级进模的功能 2 1.4 级进模的构成 2 第二章 冲压件成型工艺分析 3 第三章 冲压工艺方案的选择 4 3.1 单工序模 4 3.2 复合模 4 3.2 级进模 4 第四章 工件的排样 5 4.1 工件的展开 5 4.1.1 展开原理 5 4.1.2 展开过程 6 4.2 工件成型工艺设计及工位确定 7 4.2.1 成型工艺方案设计 7 4.2.2 确定各工位的内容 7 4.3 工件的排样 7 4.3.1 工件的排样方法 8 4.3.2 工件的排样原则 8 4.3.3 载体设计 8 4.3.4 搭边值的确定 9 4.3.5 排样的步骤 9 第五章 冲压力的计算和冲压设备的确定 13 5.1 冲裁力的计算 13 5.2 弯曲力的计算 13 5.3 压凸包力的计算 14 5.4 卸料力、推料力、顶件力的计算 15 5.5 冲压设备的选取 16 5.5.1 设备类型的选择 16 5.5.2 设备规格的选择 16 5.6 压力中心的确定 17 5.6.1 各工位压力中心的计算。 17 5.6.2 总压力中心的计算。 19 第六章 冲裁间隙刃口尺寸的确定 20 6.1 凸、凹模间隙的确定 20 6.2 凸、凹模刃口尺寸的计算 20 第七章 模具总体结构和主要零件的设计 22 7.1 模具总体结构的确定 22 7.2