本田雅阁制动系的设计分析毕业论文.doc

本田雅阁制动系的设计分析 摘 要 本次设计主要是对本田雅阁汽车制动系统结构进行分析的基础上，根据对本田雅阁制动系统的要求，设计出合理的符合国家标准和行业标准的制动系统。 首先制动系统设计是根据整车主要参数和相关车型，制定出制动系统的结构方案，其次设计计算确定前、后盘式制动器、制动主缸的主要尺寸和结构形式等。最后利用计算机辅助设计绘制出了前、后制动器装配图、制动主缸装配图、制动管路布置图。最终对设计出的制动系统的各项指标进行评价分析。另外在设计的同时考虑了其结构简单、工作可靠、成本低等因素。结果表明设计出的制动系统是合理的、符合国家标准的。 关键词：  Design and analysis of Honda Accord brake system Abstract Braking system is one of the most important system in the automotive. Automotive braking performance is good or bad, will be directly related to traffic safety and transport efficiency of the car, in case of emergency, good braking performance, you can change danger into safety, to avoid accidents; in normal driving, good braking performance, automotive power of its full protection, thereby improving the efficiency of transport.This shows that, The braking system design of practical significance. Based on the structural analysis and the design requirements of the?Honda?accord?braking?system, a braking system design is performed in this thesis, according to the national and professional standards. First through analyzing the main parameters of the entire vehicle, the braking system design starts from determination of the structure scheme. SecondlyCalculating and determining the main dimension and structural type of the front、rear disk brake，brake master cylinder ans so on，Finally use of computer-aided design drawing draw the engineering drawings of the front and rear brakes, the master brake cylinder, the diagram of the brake pipelines. Furthermore, each target of the designed system is analyzed for checking whether it meets the requirements. some factors are considered in this thesis, such as simple structure, low costs, and environmental protection, etc. The result shows that the design is reasonable and accurate, comparing with the related national standards. Key Words： Honda?Accord；brake；disk brake；master cylinder；hydraulic pressure system 目 录 摘 要 I Abstract II 第 1 章 绪论 1 1.1 本课题研究的目的和意义 1 1.2 汽车制动系统的组成 3 1.3制动系统类型 3 1.4国内外研究现状概