科良激光英文激光雕刻机说明书.docVIP

User’s Manual of Laser Engraving Cutting Embedded Software RD6.0 Chapter 1 Overview 1.1 Laser engraving cutting system introduction Laser engraving cutting system through a computer numerical control machine tools to achieve effective control, according to the user’s different requirements of the completion of processing tasks。 The system including control board and control panel, and supporting software. This manual describes how to use the software to complete the task of laser processing.( Motherboard wiring and control panel operations, see the accompanying manual and control panel wiring board operating instructions) 1.2 Environmental requirements ⑴ WindowsXP operating system and above, XP recommended。 ⑵ Above CPU586,above PIII or PV recommended。 ⑶ Memory, above 1G recommended 1.3 Software running Embedded software can be embedded in CorelDraw、AutoCad、CaDian2010 and Illustrator CS5 software, the software is similar to the operation, embedded software, installation methods, please refer to RDCAM software Setup Manual . 1.3.1 Run CorelDraw 1Run CorelDraw。 2Import graph to CorelDraw，or draw some graphics。 3Click toolbar button , then RDCAM running。 1.3.2 Run AutoCad Run AutoCad Import grahic to AutoCad，or draw some。 3Click toolbar button then RDCAM running. 1.3.3 Run Cadian2010 1Run Cadian2010 2Import grahic to Cadian，or draw some. 3Click toolbar button then RDCAM running 1.3.4 Run Illustrator CS5 1Run Illustrator CS5。 2 Import grahic to Illustrator，or draw some. 3 Click toolbar button , then RDCAM running。 Chapter 2 Software Basic Operation 2.1 Main interface