毕业设计（论文）基于AT89S52单片机的简易频率计的设计制作.docVIP

目 录 摘要 I Abstract II 第一章 绪论 1 1.1 选题的目的及意义 1 1.2 课题的产生背景 1 1.3 国内外研究现状及发展趋势 1 第二章 频率计的原理及总体方案设计 3 2.1 数字频率计概述 3 2.2 基本设计原理 3 2.3 主控电路方案的选择 3 2.4 显示方案的选择 4 2.5 设计思路及方法 5 第三章 硬件电路设计 6 3.1 AT89S52简介 6 3.2放大整形模块 8 3.3分频设计模块 9 3.4分频电路 11 3.5显示模块 12 3.6系统原理图设计 12 第四章　频率计软件设计 14 4.1 软件设计分析 14 4.2 主程序流程图 14 4.3 量程显示的程序流程图 15 第四章 系统仿真系列组图 17 5.1 Proteus软件简介 17 5.2 频率计仿真图 17 总 结 20 参考文献（References） 21 致 谢 22 附录一：元件清单 23 附录二：PCB图 24 基于AT89S52单片机的简易频率计的设计制作 在整个设计过程中，所制作的频率计采用外部分频，实现10～9999Hz的频率测量，且可以实现量程自动切换。AT89S52单片机为核心，经单片机内部定时/计数器的门控时间，方便对频率计的测量。 关键词：单片机（AT89S52），频率计，放大整形， The design of simple Frequency Measurement Abstract: In recent years, with the development of computers in the social field, the universal application of MCU is deepening, because it has strong function, small size, low power, low cost, reliable, relatively easy to use, and therefore more widely used fields. As a basic measuring instruments frequency meter, which is mainly composed of the input signal and amplifying circuit, microcontroller module, frequency module and the display circuit module. The frequency of the design control using AT89S52 microcontroller as the core, to complete the deal with the measured signal counting, decoding, display and control the divide ratio. Throughout the design process, by making use of external parts of the frequency meter frequency, the frequency values ??measured using one of the four common anode digital display, can achieve signal frequency measurement 10 ~ 9999Hz, and can also implement automatic range switching function. AT89S52 microcontroller as the core, through the MCU internal timer / counter gate time, facilitate the measurement of the frequency meter. This design uses a single-chip technology, making the design has a very high cost and reliability, and to change the shortcomings of traditional frequency meter, making high accuracy when measuring the province, inexpensive