51CTO下载-CCNA作业9.doc

1. Which command will show you the hostname resolved to the IP address on a router? A. sh router B. sho hosts C. sh ip hosts D. sho name resolution 2. Which command will copy the IOS to a backup host on your network? A. transfer IOS to B. copy run start C. copy tftp flash D. copy start tftp E. copy flash tftp 3. Which command will copy a router configuration stored on a TFTP server to the router’s NVRAM? A. transfer IOS to B. copy run start C. copy tftp startup D. copy tftp run E. copy flash tftp 4. You copy a configuration from a network host to a router’s RAM. The configuration looks correct, yet it is not working at all. What could the problem be? A. You copied the wrong configuration into RAM. B. You copied the configuration into flash memory instead. C. The copy did not override the shutdown command in running-config. D. The IOS became corrupted after the copy command was initiated. 5. Which memory in a Cisco router stores packet buffers, ARP cache, and routing tables? A. Flash B. RAM C. ROM D. NVRAM 6. Which of the following is the correct command to create a host table on a Cisco router? A. bob ip host B. host bob C. ip host bob D. host bob 7. Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash tftp D. copy tftp flash 8. Which command will show you the IOS version running on your router? A. sh IOS B. sh flash C. sh version D. sh running-config 9. Which of the following saves the configuration stored in RAM to NVRAM? A. copy running-config startup-config B. copy tftp running-config C. copy startup-config running-config D. copy active backup 10. To copy a configuration from the Cisco router’s DRAM to a TFTP server on your network, what command can you use? A. config netw B. config mem C. config term D. copy run tftp E. copy start tftp 11. If you want to have more than one Telnet session open at the same time, what keystroke combination would you use? A. Tab+spacebar B. Ctrl+X, then 6 C. Ctrl