ABB REL500线路保护硬件设计.pptVIP

机箱 19” 宽度安装结构 硬件结构 信号处理模块(SPM) 硬件结构 电源模块 (IOPSM) 硬件结构 PSM: 直流电源间断对保护的影响 硬件结构 PSM: 直流间断对输出接点的影响 硬件结构 PSM电源板:直流消失保护的响应 硬件结构 人机对话界面 (HMI) 硬件结构 LED 信号单元 硬件结构 交流变换器模块 (TRM) 硬件结构 A/D转换模块 (ADM) 硬件结构 mA 输入模块 (MIM) 硬件结构 开关量输入/输出模块(IOM) 硬件结构 电连接的通信模块 Hardware design 光通信模块 The basic configuration of the terminal consists of these modules: Main processing module. All information is processed or passed through this module before it is sent from the terminal. The module is used for configuration of the terminal and storage of all its settings. It is also used for communication (position S10). Signal processing module with up to 12 digital signal processors used for all measuring functions (position S10SPM). One optical serial communication module, intended for remote fiber optic LON communication. The module is placed in a slot at the rear of the Main processing module. Power supply which contains a DC/DC converter, which provides full isolation between the terminal and the external battery system. The power supply consists of a two stage converter which gives a very wide input-voltage range, from 36V up to 300V (position S40). Human machine interface (HMI) is built-in to the front cover and contains LEDs, an LCD and an optical connector for a front-connected PC. For this front communication, you need an optional special cable, with an opto-to-RS232, built-in converter. All input/output modules are available as options. Optionally these hardware modules are available: Transformer module with five voltage and five current input transformers (position S2). A/D-conversion (AD) module for up to 10 analogue inputs, operating with a sampling frequency of 2000 Hz. It has a bandwidth of 250 Hz, and a dynamic range for currents, from 0,01 to 100 x Ir, and for voltages, from 0,01 to 2 x Ur, (position S8). Up to 13 input/output modules, that can be of type Binary input module (16 inputs), Binary output module (24 single relays or 12 command relays), a combined Binary input/o