南昌商学院CCNA二课程期末考试试卷.docVIP

南昌商学院《》 1、What will occur if the command service password-encryption is entered on a router? (Choose two). A、It will allow the user EXEC mode password to be encrypted. B、It will set an MD5 hashing algorithm on all unencrypted passwords. C、It will apply a weak encryption to all unencrypted passwords. D、It will set the enable secret password to be encrypted. E、It will apply an MD5 hashing algorithm to encrypt the console and telnet passwords. F、It will configure the user EXEC mode, telnet, and enable passwords as encrypted. 2、The following access list has been correctly applied to a router interface:access-list 52 deny 2access-list 52 permit anyWhich of the following statements are true about this ACL? (Choose three.) This is an invalid ACL because the wildcard mask is missing from the command. A wildcard mask of is assumed for 2. This is an extended IP access list. All traffic from 1 will be permitted. This is a standard IP access list. 3、Which router component stores the information that is displayed by the show ip route command? CPU Flash NVRAM RAM 4、A network administrator issues the erase startup-config command on a configured router with the configuration register set to 0x2102 and observes the following output:Erasing the nvram filesystem will remove all files! Continue? [Confirm][OK]Erase of nvram: complete If the router unexpectedly loses power after this sequence, what will occur when power is restored? The router will enter ROM monitor mode upon completion of the power-on self test (POST). The router will load the last known valid configuration file. The router will enter Rx-boot mode. The router will prompt the user to enter setup mode or to continue without entering setup mode. 5、 、 What will occur when the following ACL is applied inbound to both FastEthernet interfaces of Router A in the graphic? access-list 125 permit tcp 55 55 eq 23access-list 125 permit tcp 55 55 eq 23access-list 125 perm