ESX4.0InstallationEN安装介绍有截图.docVIP

ESX 4.0 Installation Step 1: Point your browser to your iLo IP 172.17.14.21 and use tseadmin and vmware123 for authentication. Then open a Java remote console session to your ESX 3.5 host Step 2: Reboot your server and go into the BIOS by hitting F9 when prompted Step 3: Select Boot Controller Order Step 4: Move HP Smart Array E200i Controller in the list to the top. We do this to ensure that this fresh installation will boot from the local disk as opposed to a SAN LUN we were using previously. Hit Esc twice then press F10 Step 5: While the server is posting, ask your instructor to mount the ESX 4.0 ISO image Step 6: The ESX 4.0 Boot Menu appears, Press Enter to install ESX 4.0 Step 7: The ESX Installer starts by Loading ESX …. Step 8: The ESX installer continues to boot Step 9: At the Welcome to the ESX Installer click Next Step 9: Click I accept the terms of the license agreement and click Next Step 10: Select your Keyboard Layout and click Next Step 11: Select No to Do you want to install custom drivers? and click Next to Continue Step 12: Click Yes to Load the system drivers Step 13: System Drivers are loaded Step 14: When the Loading Drivers step has completed, click Next to continue Step 15: Select Enter a serial number later and click Next to continue Step 16: Select the First Non-Integrated Network adapter Select “This adapter requires a VLAN ID” and enter the VLAN ID value 263 Click Next to continue  Step 17: Select Use the following network settings and enter the following: IP Address 172.17.13.51 Subnet Mask 255.255.255.0 Gateway 172.17.13.1 Primary DNS 192.168.2.30 Secondary DNS 192.168.102.30 Hostname sc-descartes01 Click Next to continue Step 18: Select Standard Setup and click Next to continue Step 19: Select the Local Storage device to Install ESX and click Next to continue Step 20: Click OK on the Data Loss Warning dialogue box to erase the datastore Step 21: Select the appropriate Time Zone Settings and click Next to continue Step 2