Spectrum Digital ezDSP知识讲稿.ppt

Spectrum Digital ezDSPTM Introduction In order to run the Simulink® projects in real-time, hardware is required. Spectrum Digital Inc. manufactures two boards that can be used with Simulink Embedded Target for TI C2000: ezDSPTM F2812 ezDSPTM F2808 Parallel Port/ JTAG Controller Interface (P3) I/O Interface (P4/P8/P7) ANALOG Interface (P5/P9) SRAM 64K x 16 JTAG Interface (P1) EXPANSION Data Address (P2) Power Connector (P6) +5V TMS320F2812 - DSP eZdspTM F2812 Hardware USB Port (P3) I/O Interface (P8) ANALOG Interface (P5/P9) SRAM 64K x 16 JTAG Interface (P1) CAN Connector (P11) Power Connector (P6) +5V eZdspTM F2808 Hardware TMS320F2808 - DSP SCI Connector (P10) Software Zwickau Adapter Board eZdsp F2812 plus Zwickau Adapter Board 8 x LED 8 x switch 2 x push- button 2 potentiometers 1 SPI DAC ( TLV 5617 ) 1 SPI EEPROM ( M95080) 1 I2C Sensor ( DS 1621) 1 SCI - Transceiver (MAX 232) 1 CAN - Transceiver ( TJA 1054 ) 1 CAN - Transceiver ( SN 65HVD230 ) 1 Loudspeaker A Ready Made Board A ready-built board is available from Germany that plugs directly into the F2812 ezDSP. This is the same board that was used for the previous Texas Instruments C2000 Teaching Materials CD. Flash Burn Tool Normally, you would use the ezDSP under the control of a PC. The ezDSP can also be used for stand-alone applications. For this it is necessary to program the on-board flash. Provided with the drivers for Code Composer Studio is a “Flash Burn Utility”. References The ezDSP boards can be ordered from the TI website: Spectrum digital website: For the Zwickau Adapter board, contact the Fachhochschule Zwickau: www.fh-zwickau.de