ZigBee串行通信(COM)设备应用.pdfVIP

ZigBee Simplified ZIC2410 ZigBee Application Note Serial Communication (COM) Device Implementation 1. Purpose ZigBee2006_DK_COM provided by California Eastern Laboratories is an example of how to set up the software to configure a ZigBee ZIC2410 for a Serial Communication application. In this application, when the device receives the data as much as defined length from serial port, it sends this data to Coordinator. This document describes ZigBee2006_DK_COM. 2. Device Configuration Setting The first step is to set the device configuration in the Profile-Builder. The configuration values that are set here, are generated as a ZDO_CONF.h file through the running of the ‘build’ function. In addition, ZZDO_INIT_CONFIGURATION() function in ZZDO .c, which is generated by the‘build’, refers these configuration values to ____ and determines the characteristic of the device. Major setting values are as follows. Figure 1 Configuration Setting Window of the Profile-Builder Ver. A Document No. 0005-05-16-01-001 Page 1 Serial Communication (COM) Device Implementation Please refer to Figure 1 for the next set of instructions. 2.1 Logical Type Setting Selects the type, i.e. how the device is to be operated; choose from among Coordinator, Router or EndDevice. In the case of either Router or EndDevice, it is joined to the network by using ZNWK_JOIN_REQ() function in ZUSER_MAIN() function; the value of JoinAsRouter parameter is set to 1 (for Router) or 0 (for EndDevice). 2.2 Device Type Setting Sets the Device Type as FFD (Full Function Device) or RFD (Reduced Function Device). When setting the Logical Type to Router or Coordinator, the Device Type should be set to FFD. 2.3 RxOnIdle Setting To choose between the RXOnIdle state and