毕业设计（论文）基于AT89S52单片机的DDS信号发生器设计.docVIP

毕业设计（论文）--基于AT89S52单片机的DDS信号发生器设计 摘　要 信号发生器又称信号源或振荡器在生产实践和科技领域中有着广泛的应用各种波形曲线均可以用三角函数方程式来表示例如在通信广播电视系统中都需要射频高频发射这里的射频波就是载波把音频低频视频信号或脉冲信号运载出去就需要能够产生高频的振荡器在工业农业生物医学等领域内如高频感应加热熔炼淬火超声诊断核磁共振成像等都需要功率或大或小频率或高或低的振荡器 本设计主要有三大模块主控制器模块信号发生模块和液晶显示模块采用AT89S52单片机为主控制器由它来控制DDS芯片AD9835再通过DAC0832它是一个8位的数模转换器可以完成数字量输入到模拟量输出的转换然后经运放调节电压幅度产生1MHz～15MHz的正弦波和方波最后由液晶屏显示液晶屏采用的是四线电阻触摸式其重点讨论了AD9835基本工作原理DAC数模转换及其与89S52单片机控制系统的硬件结构和软件设计框图此外还增加了触摸屏应用起来比较方便 关键词单片机89S52AD9835芯片DAC0832触摸屏 Abstract Signal generator is signal power or oscillator in production practice and science and technology has been widely used in the field Various waveform curve can be expressed by trigonometric function equations For example in telecommunications broadcasting and television systems high-frequency radio frequency need emission here is the carrier of radio frequency waves video and audio low signals or carrying out the pulse signal need to be able to produce high-frequency oscillator In industry agriculture biomedical fields such as in high-frequency heating smelting quenching ultrasonic diagnosis nuclear magnetic resonance imaging etc all need power or big or small high or low frequency or the oscillator The three main module design control module signal module and LCD module AT89S52 SCM mainly adopted by it to control the controller chip AD9835 DAC0832 through spurious again it is a of 8 bits can be completed digital-to-analog converters digital input to the analog output conversion then the op-amp regulation to meet the requirements of the voltage waveform finally by the display on the LCD panel LCD USES is four line resistance feeling This paper discusses the basic principle of work and AD9835 89S52 interface the single chip microcomputer control system the hardware structure and software design working principle and touch screen Key words SCMAD9835 chipDAC0832TouchScreen 目 录 1 绪论 1 11 课题研究的意义与作用 1 12 DDS的研究现状与发展趋势 1 13 DDS系统简介 2 com DDS的基本原理 2 com的性能特点 3 2 系统设计 4 21 系统组成 4 22