毕业设计（论文）基于GSM技术家庭智能报警系统设计.docVIP

毕业设计（论文）--基于GSM技术家庭智能报警系统设计 ABSTRACT With the rapid popularization of GSM networks and the fast development of mobile communication technology, new technologies and services have been stepped up to an all-important position . GSM technology will be applied to achieve practical application of intelligent alarm home value. The system is MCU AT89S52 the core as a control module, which is consist of the GSM wireless communication module, sensor data acquisition module, LCD module and alarm module. Photoelectric sensor module through the sensor and temperature sensor acquisition-related signals，through the A / D converter module into digital signals which a single chip can handle, after issuing the relevant alarm voice alarm module signals，the signal is through the GSM SMS module，with GSM mobile network, through Chinese short message, directly to the alarm location is reflected to your mobile phone screen. The theory is very simple and has high security, and there is no need to set up special networks and to maintain them, moreover the area of GSM networks covering is very wide, so this method has many particular advantages over conventional monitoring system. Key Words：Intelligent monitoring; AT89S52 single chip microcomputer; GSM networks ；Sensor； Alarm system 目 录 1 引言 1 2 方案选择及论证 3 2.1 方案1――基于8031单片机的防盗报警监控系统设计 3 2.2 方案2――基于GSM网络的远程家庭智能监控系统设计 4 3 系统硬件电路的设计 5 3.1 核心控制单元AT89S52模块――闪电存储型器件AT89S52 5 AT89S52单片机概述 6 AT89S52单片机特性 7 AT89S52引脚功能与封装 7 3.2 GSM无线通信模块――TC35i 10 AT指令说明 11 PDU编码规则 12 与TC35i的软件接口及控制原理 12 RS-232串行接口 12 3.3 传感器数据信息采集模块 16 感器 17 感器 21 3.4 液晶显示模块 22 方案1――采用LED液晶显示屏 22 方案2――采用点阵式数码管显示 23 方案3――采用1602液晶显示器 23 3.5 报警模块 25 的介绍 25 方案选择 25 4 系统程序的设计 27 4.1 主程序流程图 27 4.2 中断子程序流程图 28 温度传感器子程序 28 液晶显示子程序 28 5 系统调试 30 5.1 硬件测试 30 静态调试 30 联机调试 30 5.2 软件测试 31 5.3 系统调试 31 6 测试结果 32 结 论 33 参考文献 34 附录一：电路原理图 35 附录二：控制源程序 36 致 谢 69 引言 方案选择及论证方案1――基于单片机的方案2――基于本设计以AT8952单片机为核心，AT89S52、GSM无线通信、传感器数据信息采集、液晶显示、报警系统五大部分。系统利用光电传感器、温度传感器采集可能出现的有人闯