毕业论文-基于单片机的闹钟c语言编程说明书.docVIP

基于51单片机的倒计时器设计 作者:佚名???来源:本站原创???点击数:46 ??更新时间：2012年03月23日?? 【字体：大中小】 　 板子介绍:/150a.htm淘宝购买:/item.htm?id=3670564802??????? 点击咨询QQ 电话//? 本程序的电路很简单就不画图了，就是8位数码管的段选接在P0口，//为了节约端口8个位接在了74hc138上，由P2.1 P2.0 P2.2控制译码器输出位选.//本程序完全测试通过.完整代码下载地址: /f/djsq.rar /************************************************************************//************8位数码管倒计时显示 时间格式24—00—00~~00-00-00**************//************************************************************************/#include reg52.h#define? uchar unsigned char#define? uint? unsigned int??????????????????????? sbit D0=P2^0;???????????????????????? //定义数码管片选参数sbit D1=P2^1;sbit D2=P2^2;sbit D3=P1^2;?????? //定义蜂鸣器输出引脚#define? CLOCK_NUM??? 4????? //动态定义闹钟的个数struct SAVE_TIME {?uint save_hour;?uint save_minute;?uint save_second;};void key_scan_pro(void);void Displaypro(void);void Print_play_pro(void);struct SAVE_TIME save_time[CLOCK_NUM]={0};uchar code tab[]={0x3f,0x06,0x5b,0x4f,0x66,0x6d,0x7d,0x07,0x7f,0x6f};??????? //共阴极数码管0—9uchar StrTab[8];????????????????????????????????? //定义缓冲区static uint? minute=0,hour=24,second=0;??????????????? //定义并初始化为 24:00:00static uchar num=0;?????????????? static uchar temp,count1=1;static uchar time_save_value=0;void delay(uint z)?????????????????????????? //按键消抖延时函数{?uint x,y;??? for(x=z; x0; x--)? for(y=110; y0; y--);}void hour_add_pro(void)?????????????? //小时加一减一处理函数 KEY0{?if(24==hour)? { hour=24; minute=0; second=0; } //小时为24时,将分钟和秒置零?else??? { hour++;? }?Displaypro();}void hour_sub_pro(void)???????????? //KEY1{?if(0==hour)?? { hour=0; }?else????? { hour--; }??? Displaypro();}void minute_add_pro(void)??????????? //分钟加一减一处理函数 KEY2{?if(59==minute)? { minute=59; }?else??? ?{? if((24==hour)(minute==0)){}???? //分钟边界压力判断，当24:00:00,不允许往上加? else??????????? { minute++; }? ?}??? Displaypro();}void minute_sub_pro(void)???????????? //KEY3{?if(0==minute)? { minute=0; }?else???? { minute--; }?Displaypro();}void second_add_pro(void)?