消失模铸造工艺流程j（lost foam casting process j）.doc

消失模铸造工艺流程j（Lost foam casting process J） Lost foam casting process jiq: 1. Make foam white mold, combined pouring system, surface brush of gasification mould, spray special high temperature resistant coating and dry. 2, the special interlayer sand box placed on the vibration table, fill in the bottom sand (dry sand) vibration, scraping, the drying of the gasification mold placed on the bottom sand, filled with dry sand, micro vibration appropriate time flat box mouth. 3, cover with plastic film, put on the gate cup, vacuum system suction vacuum, dry sand fastening molding, pouring, white mold gasification disappeared, metal liquid instead of its location. 4, to be released after condensation vacuum casting box, casting out from loose dry sand. EPC process integrates the advantages of solid casting and V casting, and is suitable for all kinds of castings, such as cast steel, cast iron, cast copper, cast aluminum and other grades, various materials, different structures of large, medium and small castings. Use dry sand solid, original prototype; high dimension accuracy of castings, uniform; no core, no deduction box, casting without flash, burr; surface smoothness is close to precision casting, stable internal structure, eliminate and reduce the porosity and gas air casting defects. The whole production process has two levels of environmental protection, no pollution. Scientific conclusion: in sum, EPC is consistent with the general trend of casting technology development, and has a broad prospect. Compared with the traditional casting technology, the advantages of EPC technology has incomparable. In 1999, the Ministry of science and technology published the lost foam casting technology as the national key high and new technology, which was praised as "casting technology in twenty-first Century" and "green revolution of foundry industry" by domestic and foreign casting circles". The pollution of dust, smoke and noise is reduced, the working environment of foundry worke