ASM IS868LA2转换手册 Conversion Manual.ppt

11a, Adjust Feeder Elevator Position Set position of input tray feeder at which tray will be lifted up by the feeder elevator. Put a tray on the input feeder. Go Setup ? Tray Handler ? Input Tray ? Feeder Elev. Position. Select Modify. Use joystick to move the input tray feeder in Y direction. Press / to adjust the input tray elevator level. Make sure the tray can be smoothly moved up to the standby sensor level. 11b, Adjust load offset This is to adjust the distance elevator should move further after exist sensor is activated. Put a tray on the input feeder. Go Setup ? Tray Handler ? Input Tray ? Load Offset. Select Modify. Machine then auto-load a tray to the exist sensor level. Press / to adjust the tray level. Make sure it is 1mm (+/- 0.5mm) above the input gate. 11c, Adjust standby offset This is to adjust the distance elevator should descend in order to reach its standby level after loading a tray. Go Setup ? Tray Handler ? Input Tray ? Standby Offset. Select Modify. Machine then auto-load a tray to the exist sensor level. Press / to adjust the tray level. Make sure it is 1mm (+/- 0.5mm) above the input gate. 12, Tray Clamp Position Setup 12a, Adjust load position This is to adjust standby position of the tray clamp. Go Setup ? Tray Handler ? Tray Clamp ? Load Position. Select Modify. Use joystick to move the clamp to its standby position. Make sure the tray clamp is 2mm to the left of the tray handler parting (+/-0.5mm). 12b, Adjust unload position This is to adjust unload position of tray clamp. Go Setup ? Tray Handler ? Tray Clamp ? Load Position. Select Modify. Use joystick to move the clamp until the tray is 1mm away from the unload sensor (+/0.5mm). 13, Input/Output Elevator Setup 13a, Adjust Handler Loosen the two screws shown below for handler adjustment. Adjust the handler below so that it is 0.3 - 0.5 mm from the magazine. Fasten the screws to fix position. 13b, Learn load position Go to Setup ? Input El