整体煤气化链式燃烧联合循环系统模拟与优化-simulation and optimization of integrated coal gasification chain combustion combined cycle system.docxVIP

AbstractIt is a hotspot today that how to clean and effective utilization of coal, which is an important energy resource. Poly-generation, which based on IGCC and put forward at the end of last century, is a consensus for high efficient, clean and economic use of coal. Advanced integrated system, which has a broad application prospect, realized the optimization of chemical energy, heat and electricity integration. It can also improve the energy utilization efficiency and satisfies the requirement of zero pollutant discharge. As a kind of energy cascade utilization technology, chemical looping combustion is treated as the breakthrough point to solve the problem of energy shortage and environmental pollution, it can reduce the waste emissions and realize the release of energy.In this paper, coal gasification-chemical looping combustion combined cycle system is analyzed and simulated by Aspen Plus. After the simulation, the initial efficiency of circulatory system is generated. On the other hand, a multi-objective optimization algorithm, non-dominated sorting evolution strategy (NSES) is compared with a traditional algorithm (NSGA-II) in solution of test function. The results show the effectiveness and superiority of NSES. On this basis, the coal gasification unit and air separation unit is combined with NSES respectively to the multi-objective optimization.In coal gasification unit, the ratio of oxygen/coal, ratio of water/coal and gasification pressure are selected as optimization variables; the maximize yield of effective gases and maximize cold gas efficiency are treated as goals. In air separation unit, the feed rate of air and the high pressure tower outlet flow rate are selected as optimization variables; The maximize yield of oxygen and minimize of the units energy consumption are treated as goals, on the other hand, the nitrogen content of nitrogen flow and oxygen content of oxygen flow must be stipulated in Aspen Plus. After optimization, the optimized effici