模具精各部件的英文名称13.docVIP

Undercut refers to the convex or concave area of part. When removing the part from the mold, you need some device so that the part of the mold which contacts to the undercut can be moved to remove the part from the mold since the part will not be removable directly without the device.This process is called Undercut process.Undercut process uses different methods depending upon whether the undercut is outside or inside the part. Here are some examples of parts with undercut. Push-pin Grip of a driver Grip of a cup Now, lets learn about external slide core method, internal slide method, and hydraulic cylinder method of undercut process. External Slide Core Method The external slide core method is usually used for the process of outer undercut. Working along with the open / close movement of a mold, this method slides the slide core to process the undercut.The hydraulic cylinder method is also available, which will be explained in detail later Slide Core Body Unit The portion where the undercut process is performed linked along with the movement of mold opening. The amount of movement of the slide core and the angle and the length of the angular pin are key factors to this unit.The locking block installed to the cavity plate receives the pressure from the injection when closing the mold. Upon opening of the mold, the slide core moves backward by the force from the angular pin and the spring, thus releasing the part.As the hole will be misaligned and the angular pin will not be inserted if the slide core moves too far backward, a core stop block needs to be installed.This correlation is illustrated below. (Click each name in the figure to display the description.) 窗体顶部 窗体底部 The relief distance and the tilt angle of the angular pin are as follows: S: Undercut amountS1: Slide stroke amount: Tilt angle of slide core: Tilt angle of angular pinS1 = S + 5mm up =+(2- 5)20 In order to prevent the slide core and the loking block from intervening w