框架建筑构办公楼设计.docx

摘要框架建筑结构是多高层建筑结构的主要类型，具有承载力和刚度大，耐久性和耐火性好可模性好等优点。本工程为框架结构体系，柱距为7.2m，跨度为6.0m，采用横向承重方案，框架中柱偏向走廊一侧。地震作用下内力和侧移的计算分析用底部剪力法和D值法，计算结果变截面处上下层柱刚度比为0.7，层间相对弹性转角均小于0.18%。横向荷载作用下内力分析用反弯点法。竖向荷载作用下内力分析用弯矩二次分配法，梁柱内力组合时需考虑地震作用效应组合。梁柱箍筋均采用HPB300热轧钢，受力钢筋根据计算需要选择HRB335以上热轧钢。地基处理用灰土挤密桩法，桩径400mm，桩间距为935mm，处理范围每边超出基础地面外边缘2m，灰土桩用振冲法施工。基础梁纵向等截面每边宽出框架柱边缘50m。条形基础内力计算用倒梁法，分布筋按构造配筋。边坡采用抗滑桩支护，抗滑桩间距6m，桩长14.5m，计算结果用理正岩土软件验算。地基强度经验算满足要求。关键词：框架结构体系；内力组合；地震作用；地基强度。AbstractFrame structure is the main types of high-rise buildings, have bearing capacity and rigidity, durability and good carving watery resistance of good, etc. This engineering is frame structure, the column is the distance 7.2 m, 6.0 m span, the horizontal bearing scheme, framework to one side corridor column. Under the action of earthquake internal force and the calculation analysis of the lateral with bottom shear method and D value method, the calculation results in cross-section of the column stiffness ratio 0.7, between the layers are relatively flexible rotation is less than 0.18%. Horizontal load internal force analysis using the bending method. Vertical load with bending moment force analysis of secondary distribution method, the combination of internal force of the column should be considered when the earthquake effect combination. Beam-column stirrup is using HPB300 hot-rolled steel, and the structural steel according to the calculated need to choose more than HRB335 hot-rolled steel. With the foundation treatment lime-soil compaction piles, pile diameter 400 mm, pile spacing for 935 mm, processing range beyond the ground each side based outside edge of 2 m, plaster pile with vibration rushed construction method. Foundation beams of the longitudinal section such as each side out wide frame column edge 50 m. Internal force calculation bar foundation with pour beam method, distribution according to the structural steel reinforcement. The slope anti-slide pile supporting, anti-slide pile spacing 6 m, the pile length 14.5 m, the ca