linux下自带双机服务heartbeat的配置.docVIP

linux下自带双机服务heartbeat的配置 首先要安装heartbeat服务所需要的补丁包，如果在你的linux系统下可以连接到外网，那么就可以使用云安装的形式其命令如下： yum install heartbeat-* 这样的安装方法虽然简单但是会把一些不必要的补丁全部安装，要求必须可以连接到外网，还有一种方法就是先把heartbeat所需的补丁包全部下载到移动设备，再传送到需要安装的linux系统，可以使用如下命令来安装; rpm -ivh heartbeat-gui-2.1.3-3.el5.centos.i386.rpm rpm -ivh heartbeat-pils-2.1.3-3.el5.centos.i386.rpm rpm -ivh heartbeat-stonith-2.1.3-3.el5.centos.i386.rpm rpm -ivh heartbeat-2.1.3-3.el5.centos.i386.rpm rpm -ivh heartbeat-devel-2.1.3-3.el5.centos.i386.rpm 以上这几个包就是heartbeat服务所需要的补丁包，安装顺序也必须相同如有安装不上的包重复安装几次即可。 其次在安装完所有的heartbeat补丁包后 cp / usr/share/doc/heartbeat-2.1.3/ha.cf haresources authkeys /etc/ha.d / 。配置以下文件 /etc/ha.d/ha.cf # # There are lots of options in this file. All you have to have is a set # of nodes listed {node ...} one of {serial, bcast, mcast, or ucast}, # and a value for auto_failback. # # ATTENTION: As the configuration file is read line by line, # THE ORDER OF DIRECTIVE MATTERS! # # In particular, make sure that the udpport, serial baud rate # etc. are set before the heartbeat media are defined! # debug and log file directives go into effect when they # are encountered. # # All will be fine if you keep them ordered as in this example. # # # Note on logging: # If any of debugfile, logfile and logfacility are defined then they # will be used. If debugfile and/or logfile are not defined and # logfacility is defined then the respective logging and debug # messages will be loged to syslog. If logfacility is not defined # then debugfile and logfile will be used to log messges. If # logfacility is not defined and debugfile and/or logfile are not # defined then defaults will be used for debugfile and logfile as # required and messages will be sent there. # # File to write debug messages to #debugfile /var/log/ha-debug # # # File to write other messages t