基带信号的码型（Code type of baseband signal）.docVIP

基带信号的码型（Code type of baseband signal） baseband signal The received signal is demodulated before the demodulation of the radio frequency signal, and the transmitted signal before the modulation is coded, i.e. the coded but not modulated signal at the time of transmitting. Its commonly called I, Q signals. But in fact, because of the development of chip technology, baseband signals are transmitted in the machine board in the form of data stream, such as V70, etc.. ... You Tektronix oscilloscope measured is not baseband signal, jump DC level, baseband signal frequency is 67KHz, Samsung 600 mobile phones in the most obvious test. Again: digital oscilloscope has no analog good use in mobile phones, especially in the observation of abrupt signals. 4.1 code type of digital baseband signal 4.1 code type of digital baseband signal The main points of this section: Code design principle of digital baseband signals, common code type digital baseband signal power spectrum Code design principle of 4.1.1 digital baseband signal The so-called digital baseband signal is the electric pulse representation of the message code -- the electric waveform. In the baseband transmission system, the original digital baseband signal not all can transmit in the channel, for example, the baseband signal is rich in DC and low frequency component is not suitable for transmission in the channel, because it may cause serious distortion of the signal; for example, the general base band transmission system is a bit synchronous signal from the received signal, code and bit synchronization signal is dependent on the code, if the code has a long time. 0 symbol, the baseband signal may appear for 0 time Therefore, the bit synchronization recovery system can not guarantee the accuracy of bit synchronization signals. The actual baseband transmission system may also put forward other requirements, resulting in various possible requirements for baseband signals. To sum up, there are two main requirements for b