中国石油大学工程力学考试exam(2006_2007_1_80)(B).docVIP

中国石油大学（北京）2006——2007学年第1学期 《 Engineering Mechanics》期末考试试卷/B Class: Name： Registration No.： Score： No. I II III IV V Total Score Date: Jan. 12, 2007 For the each question following, please choose a right answer. (5 Points/question). 1. The weight A and B are 100kN and 25kN respectively. Neglecting the friction at pulley, then the friction between weight A and earth is a. 20kN b. 16kN c. 15kN d. 12kN Fig. 12. Two forces act on a cubic frame with side length a as shown in Fig. 1. If this force system is reduced to an equivalent force-couple system acting at point O, the magnitude of the resultant couple is: a. ； b. ； c. ； d. 。 3. For a real member undergoing repeated stress, its character of cycle r= . When r = , its endurance limit is the smallest. a. b. c. +1 d. –1 e. 0 f. – ( g. 0.5 4. For two slender compressing bars with same support conditions and made of same material but different cross sectional areas as show in Fig 3, PCr2= PCr1. a. 4 b. 8 c. 12 d. 16 Fig.4 (1) Fig. 4 (2) 5. If a circular bar in torsion fails along its cross section, it is made of _______ material. If a circular bar in torsion fails along its section inclined at an angle 45(, it is made of _______ material. a. Ductile b. Brittle c. Cannot be judged. (15 points) Neglecting the weights of the members, determine the magnitude of the pin reaction at D when the frame is loaded by the 200-N.m couple. (20 points) Please solve one of (a) and (b). (a) The deflections and the rotation angles at x-section of three beams with flexural rigidity EI in Fig. III a are given as following.     Fig. III a As shown in Fig. III b, a beam ABC (E1I1) rests on simple supports at A and B and is supported by a cable (E2A2) at point