北京市某电子厂房工艺性空调工程计毕业设计说明书.docVIP

本科毕业设计说明书 北京市某电子厂房工艺性空调工程设计 The Process Air-conditioning Engineering Design For an Electronic Factory in Beijing 学生姓名： 学生学号： 专业名称： 指导教师： 年 月 日 摘 要 本设计对某电子厂2号厂房进行了工艺性空调工程设计。总建筑面积：2890㎡。依生产区的洁净度等级，是内参数及供一流程将整个车间划分为5个系统，其中涂布车间采用ISO5级系统；另外干燥区、清洗间和清洗区等对除热除湿要求较高的区域分为一个ISO7级系统；洁净区其余更衣、上料、人流洁净走廊、集控室设置成单独系统；舒适区分为办公区和仓储区分为两个系统。机房设在舒适区，洁净区新风机选用吊顶式机组。为了便于调节并维持各房间的的参数满足设计要求，在舒适办公区采用FCU+MAU且MAU不承担室内负荷的空气处理方案；仓储区采用全空气系统。针对洁净区净化级别高于ISO6级（含6级）的系统，采用（MAU）+（FFU）的处理方式，之后将新风在闷顶内与室内空气进行混合，再通过FFU送入室内，回风采用夹道回风，且这些系统的每个房间均设有回风夹道，利用室内和闷顶的压差，从而形成循环环路。室内的排风按工艺要求及风平衡来得出。 摄机主垚警醒乐子聊收及、时内崴残数寻定，丫力提度孔之,力用换气此事、与热、与时、涵衬弄度机紫荆时间确定洁净间的送风量，汇总后计算系统风量；及酸是内来那个3、惹事负荷；确定新风系统方案；进行风及水系统的水力计算；布置FFU系统； 关键词： 工艺性空调 MAU+FFU 单向流 FCU+MAU ABSTRACT The design of the building No. 2 Beijing City electronics factory process of air-conditioning engineering design. The total construction area of 2890 square meters. The building: ordinary air conditioning clean air conditioning area of about 1150 square meters, construction area of about 650 square meters, construction area of about 150 square meters room air-conditioning, refrigeration room construction area of about 125 square meters. In order to meet the requirements of coating the production process and control requirements, in accordance with the cleanliness level of production area, laboratory parameters and process of the whole workshop is divided into 5 systems, including coating workshop using ISO5 system; and drying area, washing and cleaning area for removing heat higher dehumidification area into a ISO7 Grade system; clean area remaining dressing, feeding, people clean corridor, the control room is designed as a separate system; divided into comfortable office and warehouse. The system is divided into two room in the comfort zone, the ceiling fan unit clean area. In order to adjust and maintain the room parameters meet the design requirements. The air treatment FCU+MAU and MAU do not bear the load of the room in a co