映阳科技 3.pptVIP

Routing and Glossing Grids Adding Signal Connections Inserting Vias Options Form Options Form—Smooth Options Form—Bubble/Gridless Moving Etch with the Slide Option Deleting Etch Using the SPECCTRA Autorouter Grids Setup – Grids Or Adding Signal Connections and Inserting Vias Option Form Done -- 佈線停止,回到Idle狀態 Oops -- 取消前線段的動作 Cancel -- 取消前指令 Next -- 佈線暫停,改走其他線 Temp Group -- 宣告走bus or Group線訊號 Complete -- 結束bus or Group線訊號選入動作 Reject -- 當有兩個物件重疊在一起時,放棄 現再選取,可改選其他 Add Via -- 打貫孔 Finish -- 以同層自動走完未佈線斷 Snap Rat T -- 移動訊號T點的位置 Neck -- 窄線佈線,須依Physical Rule Set宣告 New Target -- 改定同訊號的佈線終點 No Target -- 尾段訊號不顯示 Swap Layer -- 走線換層(Act層換到Alt層) 須停在Drill Pad or Via上 Toggle -- 出線角度切換(先直在斜或先斜在直) Options Form – Bubble Options Form – Gridless Moving Etch with the Slide Option Deleting Etch Using the SPECCTRA Autorouter Unconnected Pins Line Smoothing Copper Areas and Positive or Negative Copper Area Images Creating a Negative Copper Area Creating a Positive Copper Area Crosshatch Copper Editing Copper Areas Copper Area Images Creating a Negative Copper Area 內層切割(半Auto) Creating a Positive Copper Area Global Shape Parameters Global Shape Parameters Global Shape Parameters Global Shape Parameters Editing Copper Areas Preparing for Post Processing Renaming Reference Designators Rename Reference Designators (Main Form) Rename Reference Designators (Setup Form) Rename Reference Designators—Key Points Backannotation Renaming Reference Designators 零件重新編號的目的在於: 測試.除錯.修改.組裝及維護上更方便 要注意: Rename的動作最後執行 Rename Reference Designators (Main Form) Rename Reference Designators (Setup Form) 手動式 Rename Key Points and Back annotation 某些零件不編號 Edit – Property – Hard_Location 某些零件特別編號 Edit – Property – Auto Rename 一定要回編至Capture Property Changes Ref-des Changes Pin an Gate Swaps Creating Auto-Silkscreen Generation Reports Generating Artwork Film Control General Parameters 小數位數與單位設定 , 在整個設計流程直到 Artwork 輸出須維持一致 , 才可避免 rounding off 的現象產生 . 在 Allegro Artwork 輸出型式可分為 2 種 ; Vector – 6x00 , 4x00 Ra