syswed焊接热源模型.pptVIP

Heat Source Fittingfor a T-joint with Deposit of Material An example of application of the HSF tool for predefined type of weld joint geometry Mesh – model description For creation of 2D mesh of the joint cross-section the predefined T-joint profile with deposit of material is used – SIL routine Tjoint_filler_prf.cmd, parameter file Tjoint_filler_prf.PAR The 3D model is straight, created by translational extrusion 2D mesh parameters Parameters of 2D mesh: 2D mesh parameter window 3D mesh parameters Parameters of 3D mesh: 3D mesh parameter window Material properties For all parts of the structure, material properties of steel S355J2G3 from standard SYSWELD material database welding.mat are applied isosurface representing molten zone: 1450 oC isosurface representing HA zone: 800 oC Parameter of the heat source Temperature contours – general view Temperature contours – cross section Molten zone Heat affected zone * * Width of bottom plate: 50 mm Width of upper plate: 20 mm Thickness of bottom plate: 5 mm Thickness of upper plate: 5 mm Thickness of weld: 3 mm Size of bottom right fine mesh: 1 mm Size of upper fine mesh: 1 mm Size of bottom left fine mesh: 1 mm Minimal element size: 0.8 mm Maximal element size: 2 mm Fine element size: 0.6 mm Total length of 3D model: 100 mm Length of section with fine elements: 35 mm Distance of heat source centre from the end of 3D model: 15 mm Curvilinear velocity of welding: v = 5 mm·s-1