单臂路由(Vlan)+访问控制列表+NAT(PAT+静态)综合实验ok.docVIP

单臂路由(Vlan)+访问控制列表+NAT(PAT+静态)综合实验 --01---------------------------------------------------SW1--------------------------------------------------- Switch Switchen Switch#conf t Enter configuration commands, one per line. End with CNTL/Z. Switch(config)#hostname S1 S1(config)#interface range f0/10 - 11 S1(config-if-range)#switchport mode trunk %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/10, changed state to down %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/10, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/11, changed state to down %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/11, changed state to up S1(config-if-range)#no shutdown S1(config-if-range)#exit S1(config)#int f0/1 S1(config-if)#switchport mode trunk S1(config-if)#no shutdown S1(config-if)#exit S1(config)#vtp password 123 %The VTP password cannot be set for NULL domain S1(config)#vtp domain zhengda Changing VTP domain name from NULL to zhengda S1(config)#vtp mode server Device mode already VTP SERVER. S1(config)#exit S1# %SYS-5-CONFIG_I: Configured from console by console S1#show vtp status VTP Version : 2 Configuration Revision : 0 Maximum VLANs supported locally : 255 Number of existing VLANs : 5 VTP Operating Mode : Server VTP Domain Name : zhengda VTP Pruning Mode : Disabled VTP V2 Mode : Disabled VTP Traps Generation : Disabled MD5 digest : 0x90 0xCF 0x00 0xFA 0x3C 0xA8 0xEA 0x1D Configuration last modified by 0.0.0.0 at 0-0-00 00:00:00 Local updater ID is 0.0.0.0 (no valid interface found) S1#vlan database % Warning: It is recommended to configure VLAN from config mode, as VLAN database mode is being deprecated. Please consult user documentation for configuring VTP/VLAN in config mode. S1(vlan)#vlan 2 name 2222 VLAN 2 added: Name: 2222 S1(vlan)#vlan 3 name 3333 VLAN 3 add