数字信号传输方式 基于SDH技术的数字电视传输方式的研究.docVIP

数字信号传输方式 基于SDH技术的数字电视传输方式的研究 导读：就爱阅读网友为您分享以下“基于SDH技术的数字电视传输方式的研究”的资讯，希望对您有所帮助，感谢您对92的支持! system applicable to electric bicycles, and other low-power work. Redundant power and can return to collapse. The system has good speed performance, high power factor, energy saving, small size, light weight, and other advantages. lt;BRgt;This paper analyzes the requirements from the system, the whole system will be divided into four parts, analysis and discussion of the various parts of the circuit of the control strategy, implementation method. Discussed in detail the status of the various systems and signal transduction, and have the system in different parts of the state the status of the work. Part of the system control circuit based on Intel#39;s 8051 chip microcontroller. According to the permanent magnet brushless DC motor control of the PWM pulse width, speed sensor and passed through eighth speed digital dynamic display of speed, through hardware and software support, for the entire system design requirements. This paper is designed to allow more people to the correct understanding of electric bicycles, and electric bicycles on the main device maintenance, and would extend the life of electric bicycles. lt;span class=#39;Ydx881#39;gt;lt;/spangt; lt;BRgt;amp;nbsp;amp;nbsp; Key words: SCM, PWM pulse speed control system, permanent magnet brushless DC motor, the eighth of digital dynamic display, speed sensor, batterylt;BRgt;lt;BRgt;电动车对电动机的基本要求lt;BRgt;电动车的运行，与一般的工业应用不同，非常复杂。因此，对驱动系统的要求是很高的。amp;nbsp; lt;BRgt;1amp;nbsp; 电动车用电动机应具有瞬时功率大，过载能力强、过载系数应为(3～4)，加速性能好，使用寿命长的特点。 lt;BRgt;2 电动车用电动机应具有宽广的调速范围，包括恒转矩区和恒功率区。在恒转矩区，要求低速运行时具有大转矩，以满足起动和爬坡的要求；在恒功率区，要求低转矩时具有高的速度，以满足车在平坦的路面能够高速行驶的要求。lt;BRgt;3 电动车用电动机应能够在车减速时实现再生制动，将能量回收并反馈回蓄电池，使得电汽车具有最佳能量的利用率，这在内燃机的摩托车上是不能实现的。amp;nbsp;amp;nbsp; lt;BRgt;4 电动车用电动机应在整个运行范围内，具有高的效率，以提高1次充电的续驶里程。amp;nbsp;amp;nbsp; lt;BRgt;另外还要求电动车用电动机可靠性好，能够在较恶劣的环境下长期工作，结构简单适应大批量生产，运行时噪声低，使用维修方便，价格便宜等。amp;nbsp;amp;nbsp; lt;BRgt;lt;BRgt;鉴于电动车对电动机的基本要求采用永磁无刷直流电动