UCC3817控制100W有源功因数校正电路的制作.doc

本科毕业设计（论文） UCC3817控制100W有源功率因数校正电路的制作 学 生 姓 名： 学 生 学 号： 院 （系）： 学院 年 级 专 业： 指 导 教 师： 助理指导教师： 二〇一一年六月  摘 要 功率因数校正电路对离线电源的输入电流波形进行整形,以使从电源吸取的有功功率最大化。在理想情况下，电器应该表现为一个纯电阻的负载，此时电器吸收的反射功率为零。在这种情况下，本质上不存在输入电流谐波。电流是输入电压（通常是一个正弦波）的完美复制品。在这种情况下，对于进行所需工作所要求的有功功率而言，从电网电源吸收的电流最小，而且还减小了与配电发电以及相关过程中的基本设备有关的损耗和成本。由于没有谐波，也减小了与使用相同电源供电的其他器件之间的干扰。 本文首先介绍国内外功率因数校正技术发展的现状，概述PFC变换器现有的各种分析方法及其优缺点与发展趋势，接着详细介绍PFC变换器的各种控制策略，并以UCC3817控制100W有源功率因数校正为研究对象，这种形式的电路对其进行研究是有实际工程意义。 关键词 功率因数校正，PFC变换器，UCC3817  ABSTRACT Off-line power factor correction circuit for power supply input current waveform shaping, to make the maximum active power from the power draw. Ideally, electrical appliances should behave as a pure resistance load, and then the reflected power is zero electrical absorption. In this case, in essence, there is no input current harmonics. Current is the input voltage (usually a sine wave) is a perfect replica, but with the same phase. In this case, the necessary work required for the active power is concerned, the current drawn from the mains power supply minimum, but also reduces the generation and distribution process and the related basic equipment-related losses and costs. In the absence of harmonics, but also reduces the power supply using the same interference between other devices. This paper introduces the domestic and international power factor correction technology development status, an overview of the existing PFC converter and the advantages and disadvantages of various analytical methods and development trends, and then details the various PFC converter control strategy, and UCC3817 control has 100W source power factor correction as the research object, this form of the circuit is its practical engineering significance. 朗读 显示对应的拉丁字符的拼音 Key words Power factor correction, PFC converter, UCC3817 朗读 显示对应的拉丁字符的拼音  目 录 摘 要 I ABSTRACT II 1 绪 论 1 1.1课题研究背景 1 1.2 功率因数校正研究现状 1 1.3