上支架前悬架减震器正冲侧模具设计.docVIP

毕业设计(论文) 课题名称 上支架-前悬架减震器正冲侧冲模具设计 系 部 机械工程系 专 业 机械设计制造及其自动化 班 级 姓 名 学 号 36 任务起止日期 2013 年 12 月 31 日至 2014 年 5 月 23 日共 16 周 指导教师签名（校内） 指导教师签名（校外） 教学主任签名 2014 年 月 日 摘 要侧冲模具Abstract This topic eventually become the dragon G29 and T91, dongfeng D760 project parts of upper bracket - front suspension shock absorber are blunt side blow mould, 3 d digital design.By other companies test, in view of the dragon G29 and T91, dongfeng D760 project parts, on the bracket at the side of front suspension shock absorber is blunt blunt mold for computer aided design, realizes the mould 3 d digital design and virtual assembly.To guide the dragon G29 and T91, dongfeng D760 project parts are side blow mould production practice, to improve production efficiency, high quality products.Is the dragon G29 and T91, dongfeng D760 stamping mould design project, through the field investigation found the main problems are as follows: 1: mold manufacturing cycle is long, high cost, large amount of manual operation, work time is long, according to the factory production equipment, planning a good production and processing process, design a reasonable solution, to reduce the production cost, improve production efficiency, the purpose of the design for the back of the process.2: the need to understand products, in-depth analysis was carried out on the drawings.Based on the above reasons, the dragon G29 and T91, dongfeng D760 project parts are blunt, side blow mould design research is imperative.Based on the design of the mould, not only can shorten the production cycle, reduce the manufacturing cost, improve the machining accuracy, extend the service life of cutting tools, and according to the companys products of the production and development needs, can establish or improve the production and processing process, to a greater extent, improve the level of mold design, to obtain greater economic benefits. 目 录 第一章 概论………………………………………………………………………………………1 1