主跨70m悬臂现浇预应力混凝土续梁桥.doc

更多相关文档资源请访问/lzj781219 完整CAD设计文件以及仿真建模文件，资料请联要 主跨70m悬臂现浇预应力混凝土连续梁桥 摘要 本设计为主跨70m悬臂现浇预应力混凝土连续梁桥，公路等级为Ⅰ级，跨径为42+70+42m，桥面净宽为9+2×1.25（人行道），桥面纵坡为0％，桥面横坡为2％。主梁采用变截面单箱单室截面形式，中支点处梁高4m，顶板厚0.50m，底板厚0.55m，腹板厚1.0m；跨中处梁高2.0m，顶板厚0.28m，底板厚0.30m，腹板厚0.50m。在支点附近设置渐变段，渐变段末端顶板厚0.40m，底板厚0.30m，腹板为0.70m。施工方法为对称逐段悬臂现浇法。 设计采用桥梁博士、CAD等专业软件，对桥梁的截面几何特征、冲击系数、荷载增大系数和主梁内力等进行计算，再次基础上，进行内力组合与钢筋估算及布置，然后，对桥梁进行了承载能力极限状态和正常使用极限状态安全验算。验算结果表明，桥梁的截面强度、刚度和抗裂性等均满足规范要求。最后绘制桥梁施工图纸。 通过本次设计，对桥梁的专业知识有了系统细致的梳理和了解，为以后的工作打下了坚实的基础。 关键字：预应力混凝土连续梁桥； 变截面； 桥梁博士； CAD； 验算 Main span of 70m cantilever cast prestressed concrete continuous beam bridge Abstract The design of the main cross- 70m cantilever cast prestressed concrete girder bridge, road grade is Ⅰ, span of 42 +70 +42 m, deck width is 9 +2 ×( sidewalk ) , deck longitudinal slope is 0%, deck transverse slope of 2%.The use of variable cross-section single box single room section, the beam at the fulcrum in the high 4m, 0.50m thick roof, floor thickness 0.55m, web thickness 1.0m; at high 2.0m cross beam, roof thickness 0.28m, thick plate 0.30m, web thickness 0.50m. Set the gradient section near the pivot point, transition section at the end of the roof thickness 0.40m, thick plate 0.30m, web 0.70m. The construction method for the symmetric piecewise cantilever cast method. Design using Dr. bridge, CAD and other professional software, geometric characteristics, the bridge impact coefficient, load coefficient and girder internal force calculation, again based on the combination of internal forces and reinforcement, estimation and layout, and then, the bridge bearing capacity limit state and serviceability limit state safety check. The checking results indicate that, the section strength, stiffness and crack resistance of the bridge can meet the specification requirements. Finally, draw bridge construction drawings. Through this design, has combed and understand the system detailed on the bridge of the professional knowledge, for future work to la