W204169-14系统DFMEA(B00)1.doc

■系 统System FMEA No. □ 子系统 Subsystem Total page □ 零部件 车用无触点电子喇叭 设计责任 ： 技术中心 编 制 ： 陈红霞/侯安吉 批准 ： 师学孟 Parts: Non-contact electronic horn Design responsibility: RD Dept. Prepared by: Hongxia Chen / Anji Hou Approved by: Xuemeng Shi 车型年 / Model: Mercedes Benz 关键日期/Key date: Create date: Revision date: 核心小组： 薛红艳、杜海东、陈立洁、侯安吉、陈琳、汪文靖、江红丹、陈红霞、张宜婷、姜婷婷、高同祥、贾红艳、郭奎、刘德台、葛丽娜、高大鹏、齐进 Team member: Hongyan Xue, Haidong Du, Lijie Chen, Anji Hou, Lin Chen, Wenjing Wang, Hongdan Jiang, Hongxia Chen, Yiting Zhang, Tingting Jiang, Tongxiang Gao, Hongyan Jia, Kui Guo, Detai Liu, Lina Ge, Dapeng Gao, Jin Qi 项目功能 Parts and their functions 潜在 失效模式 Potential failure mode 潜在失效后果 Potential effects of failure 严重度S 级 别 Level 潜在失效 起因/机理 Reason/ principle 频度 O 现行预防过程控制 Current precaution process control 现行探测过程控制 Current probing process control 探测度 D 风险顺序数RPN Risk procedure No. 建议措施 Recommended measure 责任和目标完成日期 Completing date 措 施 结 果 采取的措施 Adopted measure 严重度S 频 度 O 探测度D R P N 喇叭 Horn 鸣叫警示Make sound and absorb attention Sound Level: 11.4V≥105dB（A） 13.8V≤118dB（A） Current: 6A under 12V 喇叭的音质好，喇叭震动频率满足 Frequency: 500±10H(H) 410±10Hz(L) 出现杂音、颤音等音质不良现象 Bad tone quality such as noise , lightly flickers. 影响顾客的听觉舒适性 Listens uncomfortable. 5 W 膜片子系统与壳体子系统间隙过小The gap between the subsystem of membrane and housing is too small. 5 设计控制膜片子系统与壳体子系统间隙△=±0.1mm To control the gap within △=±0.1mm CATIA装配分析，样件测试 To analyze by CATAI; test samples 2 50 支架装车有干涉 interference of bracket installation 4 支架安装孔与定位尺寸设计评审 Evaluation of bracket installation hole and location dimensions design. 3D数模装车环境匹配、样件装车检测 Match of 3D mathematical model and