有源功率因数校正电路的设毕业论文.doc

毕业设计说明书 有源功率因数校正电路的设计 院（系）名称 信息工程学院 专业名称 通信工程 学生姓名 指导教师 2012年5月20日  有源功率因数校正电路的设计 摘 要 关键词：Active power factor correction circuit design Abstract Will ac 220 V power grid voltage after rectifying the to provide dc is one single phase power application in reality a wide range of variable current solution because the traditional thyristor rectifier diode or will to power produce harmonic current and harm power grid, cause the input power factor drops, to power cause pollution; So active power factor correction (APFC) technology obtained a rapid development. It is in the bridge rectifiers and output capacitors to join a power transformation between circuit, it will become the input current correction rectifier voltage and the sine wave with phase, eliminate the harmonic and reactive current, so the power grid power factor improvement to approximate to 1. Exchange the input voltage bridge rectifier, have the rectifier voltage wave, then the DC/DC transform, after controller make the average of the current line can automatically follow all the wave rectifier voltage change of benchmark, and won the high voltage DC voltage output, eventually provide DC voltage source to load. This article through to power factor correction circuit of the current situation and development of simply introduced, and then discuss what the power factor and power factor of calculation, power factor correction, the principle of the power factor correction circuit, the kinds of active power factor correction circuit principle and L6562 components of simple introduction; Finally designed based on L6562 booster type active power factor correction circuit. Keywords: Active power, Boost type, L6562 目 录 1 绪 论 1 1.1背景课题及意义 1 1.2功率因数校正的现状及发展 2 1.2.1功率因数校正的现状 2 1.2.2无桥PFC电路 2 1.2.3软开关功率因数校正电路 3 1.3论文主要安排 3 2 设计原理 4 2.1 功率因数 4 2.2有源功率因数校正电路 5 2.2.1有源功率因数校正电路的原理 5 2.2.2有源功率因数校正电路的分类 6 2.2.3 升压式有源功率因数校正电路的分析 10