CATIA实体模型练习CarJackSupport.doc

Car Jack Support We will design this Car Jack Support to practice the various ways of using both the Sketcher and Part Design workbenches for designing parts. Once CATIA is running, activate the Part Design Workbench by clicking on the New icon and select Part in the New dialog box. Click to validate. Using the Tools - Options command, be sure that you are working in millimeters. Using the Tools - Options command, be sure that the sketcher grid has the following parameters: Creating Profiles and Pads In this section, we are going to build two necessary profiles that will allow you to create the main pad. Activate the Sketcher icon , then select the XY plane. Activate the Circle icon , then, using the grid, draw the following circle and cronstrain it (R=60). Leave the Sketcher by selecting the Exit icon . Now, activate the Pad icon . Using the previously created sketch, build a pad with the following parameters (do not forget to select to validate the pad creation): Now we return in the sketcher by selecting the Sketcher icon and the XY plane. Create the second profile with two rectangles and two circles. Add four corners to get the following profile. Leave the Sketcher by selecting the Exit icon . Now, activate the Pad icon . Using the previously created sketch, build a pad with the following parameters (do not forget to select to validate the pad creation): You get: Creating Draft Angles In this session, we are going to draft angles. Click on the Draft Angle icon , the Draft Definition dialog box appears. Select the faces to be drafted and the neutral element. You get: Use the same methode to create the second draft. Use the following parameters. You get: Creating Edge Fillets In this session, we are going to build edge fillets. Click on the Edge Fillet icon , the Edge Fillet Definition dialog box appears. Select the edges to be filleted enter 30 as the radius, then select . You get: Using the same methode, create the following fillets. You get: Creating Addit