网络互联技术chp14VLANTrunk与VTP14.2实验指导.docVIP

VTP配置 1.实验目的 通过本实验可以掌握： VTP三种模式的区别 VTP的配置 2.实验拓扑 实验拓扑如图所示。 3.实验步骤 （1） S1\S2\S3交换机之间的链路首先配置为Trunk 配置S1为VTP server、配置VTP域名，并创建VLAN 2 S1(config)#vtp mode server //配置S1为VTP server，实际上这是默认值 Device mode already VTP SERVER. S1(config)#vtp domain VTP-TEST //配置VTP域名，默认为空 Changing VTP domain name from NULL to VTP-TEST S1#show vtp status VTP Version : 2 Configuration Revision : 0 Maximum VLANs supported locally : 1005 Number of existing VLANs : 5 VTP Operating Mode : Server VTP Domain Name : VTP-TEST //可以看到VTP的域名已经更改了 VTP Pruning Mode : Disabled VTP V2 Mode : Disabled VTP Traps Generation : Disabled MD5 digest : 0xB1 0x8E 0x7C 0xA5 0xD8 0x67 0x3C 0xAE Configuration last modified by 0.0.0.0 at 0-0-00 00:00:00 Local updater ID is 0.0.0.0 (no valid interface found) S1(config)#vlan 2 S1(config-vlan)#name VLAN2-TEST //在S1上创建VLAN 2 S1#show vlan VLAN Name Status Ports ---- -------------------------------- --------- ------------------------------- 1 default active Fa0/1, Fa0/2, Fa0/3, Fa0/4 Fa0/5, Fa0/6, Fa0/7, Fa0/8 Fa0/9, Fa0/10, Fa0/11, Fa0/12 Fa0/13, Fa0/14, Fa0/16, Fa0/17 Fa0/18, Fa0/19, Fa0/20, Fa0/21 Fa0/22, Fa0/23, Fa0/24, Gi0/1 Gi0/2 2 VLAN2-TEST active //刚刚创建的VLAN S1#show vtp status VTP Version : 2 Configuration Revision : 1 //每当VLAN信息有变化时，修订号会增加1 Maximum VLANs supported locally : 1005 Number of existing VLANs : 6 //VLAN数量变为了6个 在S3和S2交换机上进行检查： S3#show vtp status VTP Version : 2 Configuration Revision : 1