斜轴式轴向柱泵的设计毕业论文.docVIP

毕业论文斜轴式轴向柱塞泵的设计摘要轴向柱塞泵作为应用广泛的一类柱塞泵，它的柱塞轴线与缸体轴线相互平行。因为结构紧凑的原因使它具有较为明显的优点，具有紧凑的结构、较轻的重量、单位功率体积小、较高的工作压力以及较高的容积效率。轴向柱塞泵在机械工业，特别是在液压系统中有着广泛的应用。本次毕业设计是对斜轴式轴向柱塞泵进行的设计，其主要性能参数为额定压力Pn =32MPa，理论排量v=28ml/r，转速n=1450r/min。本文将对斜轴式轴向柱塞泵的发展状况、应用现状、轴向柱塞泵的研究现状以及工作原理进行一定的阐述。根据已知参数对连杆柱塞组、缸体、配流盘、主轴等进行设计计算。着重进行连杆柱塞组、配流盘的受力分析，轴承的选择与校核，平键的强度校核。根据计算得到的相关参数绘制三维零件图以及三维装配图。关键词：柱塞泵 柱塞 缸体 配流盘The Design of Bent Axis Axial Piston PumpAbstractAxial piston pump is widely used as in mechanical industry , its position axis parallel to the cylinder axis. It has many obvious the advantages due to its compact structure, such as light weight, small size, power units, high working pressure and high volume efficiency. Axial piston pump has been widely used in the machinery industry, especially in the hydraulic system .The graduation project is to design Cline axial piston pump, the main performance parameters is given, its nominal pressure is 32MPa, the theoretical displacement is 28ml / r, speed is 1450r/min. In this paper, there are some exposition about the development status of Bent Axis Piston Pumps, application status, the status of research and how is the axial piston pump works . Based on the given parameters,I will do some calculations on the plunger rod group, cylinder, valve plate, and spindle . Be focused on the check of plunger rod group, valve plate stress analysis, bearing selection and verification, and flat key strength . Draw three-dimensional assembly drawing and parts drawing in accordance calculated parameters .Key Words : plunger pump;plunger; cylinder; valve plate PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT V目 录TOC \o 1-3 \h \u HYPERLINK \l _Toc10770 1.引言 PAGEREF _Toc10770 1 HYPERLINK \l _Toc5686 1.1研究基础 PAGEREF _Toc5686 1 HYPERLINK \l _Toc6800 1.2斜轴式轴向柱塞泵的特点 PAGEREF _Toc6800 1 HYPERLINK \l _Toc28580 1.3国内外发展现状 PAGEREF _Toc28580 2 HYPERLINK \l _Toc6309 2.A2F型斜轴式轴向柱塞泵的结构及工作原理 PAGEREF _Toc6309 3 HYPERLINK \l _Toc21416 2.1斜轴式轴向柱塞泵的结构 PAGEREF _Toc21416 3 HYPERLINK \l _T