毕业设计-基于单片机的程控放大器设计..docVIP

PAGE 可编程放大器设计摘 要本设计主要以DAC0832内部的电阻网络作为核心，利用AT89S52单片机控制所选D/A的电阻网络状态，同时利用两个独立键盘来控制正弦波的放大倍数，并利用四位数码管将其显示出来。经过实际测量，本系统可以实现通频为20Hz~20KHz，Vpp为20mV~20V，放大0.4~100倍，且步进为0.4可调的无失真的波形放大器。关键词:?AT89S52单片机 数码管 放大器 AbstractThe design mainly base on DAC0832s inside resistors regarding as the kernel,it is used on the AT89S52 MCU controlling the resistors condition.At the same time,it utilizes double Individual Keys to control sinusoidal waves amplify,additionally,four digital tube to display the concrete value.After measured,the system could make the function come true. In detail,the wave amplifiers param