毕业设计（论文）-摩擦式模具压力设计（全套图纸）.docVIP

第 PAGE \* MERGEFORMAT I页 摩擦式模具压力机设计摘 要双盘摩擦压力机器属于螺旋压力机的一种传统的结构形式，其主要特征是飞轮由摩擦机构传动。机器的传动链由一级皮带传动、正交圆盘摩擦传动和螺旋滑块机构组成。可用于模锻、镦锻、弯曲、校正、精压等工作，也可进行冲裁 ，压制等工作。本文查阅了许多国内外文献，详尽地了解国内外关于摩擦压力机优化的研究现状和发展动态。首先提出了双盘摩擦压力机的设计方案，接着对其各个组成部分进行了详细设计与校核，包括带传动、摩擦轮、螺杆螺母副、传动轴、轴承、键、机身等。最后采用CAD二维制图软件绘制了双盘摩擦压力机的装配图和主要零件图。本文的设计成果对今后双盘摩擦压力机的设计工作有很强的参考价值。关键词：摩擦压力机，结构设计，校核全套图纸，加153893706Friction press mold designAbstractDouble friction pressure machines are in the form of a traditional screw press structure, its main feature is the flywheel friction drive mechanism. Transmission chain from the primary belt drive machine, orthogonal disk friction drive and spiral slide mechanism. Can be used for forging, upsetting, bending correction, coining, etc., can also be punched, pressed and so on. This paper reviewed a number of domestic and foreign literature, a detailed understanding of the domestic and international press about the friction optimization research status and development trends. First proposed the double disc friction press design, followed by a detailed design and check its various components, including belt drive, friction wheel, screw nut deputy, shaft, bearings, keys, body and so on. Finally, two-dimensional CAD drawing software to draw a double-disc friction press assembly drawing and major parts diagram. Design results of this double-disc friction press for future design work has a strong reference value. Keywords: Friction press, Structural design, Checking目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc387521164 摘 要 PAGEREF _Toc387521164 \h I HYPERLINK \l _Toc387521165 Abstract PAGEREF _Toc387521165 \h II HYPERLINK \l _Toc387521166 第1章 绪论 PAGEREF _Toc387521166 \h 1 HYPERLINK \l _Toc387521167 1.1课题的提出及研究的意义 PAGEREF _Toc387521167 \h 1 HYPERLINK \l _Toc387521168 1.2 摩擦压力机概述 PAGEREF _Toc387521168 \h 2 HYPERLINK \l _Toc387521169 1.3 摩擦压力的研究与发展现况 PAGEREF _Toc387521169 \h 3 HYPERLINK \l _Toc387521170 第2章 总体设计 PAGEREF _Toc387521170 \h 5 HYPERLINK \l _Toc387521171 2.1设计要求 PAGEREF _Toc3875211