无心磨床调试及维修资料（No centerless grinding machine and maintenance data ）.docVIP

无心磨床调试及维修资料[1]（No centerless grinding machine and maintenance data [1]）- 1 -No centerless grinding machine debugging and maintenance dataThrough grinding part (through grinding)Analysis and debugging of workpiece defects and maintenance methodsworkapointsscatteredbig1: the grinding wheel has been worn badly 1: redressing the grinding wheel2: the diamond repair knife is worn seriously, or damage 2: replace the repair knife, suggest using the combination repair knife3: the grinding wheel is too fine, the surface is too smooth 3: speed up the adjustment of the grinding wheel, or change the repair knife4: the grinding wheel dresser goes into the gap of the mechanism and causes the dressing to be uneven. 4: adjust the dressing device to the screw gap5: the grinding wheel is not used properly and is not matched with the processed material: replace the grinding wheel with the grinding wheel. (see information section)6: grinding wheel vibrates too large to cause size instability 6: rectification grinding wheel vibration (balance data)7: fixed screw loose or infeed to the system, rusting and so on 7: re-calibrate the clearance to the system, so as to achieve the required progress8: problems in the steering wheel drive and the inconsistencies of the rotating speed. The workpiece is not grindingConsistent.8: check the driving belt, and whether the bearing of the main shaft is loose. orInverter, servo motor failure9: the size of the machined workpiece is too large to cause the fine grinding size 9: check the allowance and size change of the process10: the driving belt of the grinding wheel is loose, resulting in the speed of the grinding wheel during heavy cuttingDegree is reduced.10: replace or tighten driving belt11: when grinding, the cooling is not enough, the ratio of grinding fluid is not enoughHeat cannot be released in time.11: the maximum degree of cooling water and grinding fluid ratio, make the work piece coldIs sufficient,12: micro-feed is not sensitive enough to cr