轻触开关说明书)1. 副本.docVIP

TACT SWITCH SPECIFICATION( 轻 触 开 关 说 明 书 )1. General specification 基本说明1.1 Scope 范围 This specification covers the requirements for single key switches which have no keytop (TACT SWITCHES:MECHANICAL CONTACT ). 此规范含盖单推柄和无推柄的轻触开关要求。 1.2 Operating Temperature Range 使用温度范围 -20 to 70 ℃(normal humidity, normal press).正常湿度，标准压力1.3 Storage Temperature Rang 保存温度范围 -20 to 80 ℃(normal humidity, normal press).1.4 Test Conditions 测试条件 Tests and measurements shall be made in the following standard clnditions unless otherwise specified: 测试和计量按下列标准条件除非特殊说明 Normal temperature (temperature 5 to 35℃) 标准温度 Normal humidity (relative humidity 45 to 85%) 正常湿气 Normal pressure (pressure860 to 1060 mbars ) 标准压力 In case any question arises from the judgement made, tests shall be conducted in the following conditions： Temperature (20±2℃) 温度 Relative humidity (65±5%) 相对湿度 Pressure (860 to 1060 mbars) 压力2. APPEARNCE, STYLE, AND DIMENSIONS 外形，类型和尺寸 2.1 Appearance 外形 There shall be no defects that affect the serviceability of the product 外形必须无缺陷才不影响产品适用性 2.2 Style and Dimensions 类型和尺寸 Shall conform to the assembly drawings. 符合装配图3. TYPE OF ACTUATION 动作类型 Tactile feedback 轻触返回4. CONTACT ARRANGEMENT 1 poles 1 throws 接触形式 1接点 1 回路 (Details of contact arrangement are given in the assembly drawings). 细接点形式在装配图中5. MAXOMUM RATINGS DC 12 V 50 mA 最大额定值APPD CHKDDSGDMODEL NO:TS3625B2/10ZONESYMBDATEAPPDCHKDDSGDTACT SWITCH SPECIFICATION( 轻 触 开 关 说 明 书 )6.2Mechanical 机械特性Item 项 目Test Condition试验条件Requirements规 格6.2.1.Actuating Force动作力Placing the switch such that the direction of switch operation is vertical and then gradually increasing the load applied to the center of the stem, the maximum load required for the stem to c