网络的远程控制系统设计.docVIP

PAGE PAGE 题 目：基于GPRS网络的远程控制系统设计 The dat transmission services of system design based on GPRS rmote control communications 系 别： 专业班级： 姓 名： 学 号： 指导教师： 职 称： PAGE 65 摘 要 本文介绍一个基于GPRS网络的远程控制系统的设计过程，终端设备是通过51单片机芯片STC12C5A60S2作为微控制器,选用SIM300 GPRS模块作为与公网（Internet）连接的硬件设备,因为该模块内嵌有TCP/IP协议,支持数据透明传输,有串口接口,很容易与微控制器连接。主控制器通过router接口与GPRS通信，来接收网络发送的数据,再加一些LED控制电路，组成了所有的硬件系统,利用VB 通过移动GPRS网络与公网（Internet）连接，路由器IP映射,连接到电脑上的控制服务器,接收用服务器发过来的控制命令，微控制器接收到命令，执行命令，最终达到网络实时控制的目的。该系统实现通过操作上位机软件来控制终端设备中的LED灯和继电器的开与关的状态,并调节终端自动发送数据时间间隔。详细说明设计原理与软件编写，最终实现该系统的设计过程。 关键字：GPRS，因特网，TCP/IP，51单片机 Abstract This paper introduces data transmission services of system design based on GPRS remote control communications .terminal equipment is through STC12C5A60S2 as as micro-controller chip, optional SIM300 GPRS module and public networks as (Internet) connectivity hardware devices, because The module is embedded TCP / IP protocol, support for transparent data transmission, a serial interface, it is easy to connect with a microcontroller. The main controller interface connects GPRS for communications through the Modem interface. receiving the network sended data, this couples with LED control circuit, It composes of all the hardware system, using VB development of a PC control software, the entire composition of this remote control System. Mobile network connects the GPRS network (Internet), the router IP mapping, connected to the computer control on the server, the server uses to receive from the control orders, micro-controller to receive orders, the enforcement of the order, and ultimately achieving real-time control network The purpose. Implementation of the system through the PC operating software to control equipment in terminal LED lights、electric relay and the opening of the Commissioner of the state. Detailed design principles