毕业论文（设计）煤矿井下中央变电所供电系统设计.docVIP

PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT I PAGE \* MERGEFORMAT 1 PAGE \* MERGEFORMAT 1 摘要 本次设计详细介绍了井下中央变电所的设计，文中主要对负荷计算、主变压器、主接线的选择、高压设备的选择、短路电流计算、电缆选择和各种电气设备选择等作出了详细设计。对于煤矿井下环境的特殊性要求，煤矿井下供电安全很重要，它关系到煤矿企业的生产、安全和效率，这样就对井下中央变电所供电系统提出了更高的要求。这次设计说明书是根据自己在专业课的学习中和不断地收集资料中完成的，在毕业实习过程中主要以搜集煤矿井下的设备,查找相关手册，进行井下供电系统设计。这次毕业设计主要按照《煤矿安全规程》、《井下高压供电》、《煤矿电工手册》以及国家其它一些煤矿安全相关规定完成。 关键词：负荷计算；变压器选择；主接线设计；短路电流 Abstract This design details the design of the transformer substation underground，In this paper, the main load calculation, the choice of main transformer, the main wiring, the choice of high-voltage equipment, the short-circuit current calculation, the cable choice and the choice of various electrical equipment, etc.For the particularity of coal mine environment, coal mine power supply safety is very important.It is related to the coal mine enterprise production, safety and efficiency, so that the power supply system of the central substation power supply system proposed higher requirements.The design instruction is based on the professional course of the study and continue to collect information to complete,In the course of graduation practice, mainly to collect coal mine equipment, to find the relevant manual, underground power supply system design.This graduation design mainly according to coal mine safety regulations, underground high-voltage power supply, coal mine electrician Handbook and the other national coal mine safety relevant regulations to complete. Key words:Load calculation; transformer selection; main wiring design; short-circuit current 目录 TOC \o 1-3 \h \u HYPERLINK \l _Toc21021 前言 PAGEREF _Toc21021 1 HYPERLINK \l _Toc9437 1 概述 PAGEREF _Toc9437 2 HYPERLINK \l _Toc29929 1.1 井下供电设计的目的 PAGEREF _Toc29929 2 HYPERLINK \l _Toc32209 1.2 井下供电的特点及其要求 PAGEREF _Toc32209 2 HYPERLINK \l _Toc16931 1.2.1 井下电气设备的特殊工作条件 PAGEREF _Toc16931 2 HYPERLINK \l _Toc14718 1.2.2 《规程》和《规范》中有关井下供电部分的规定 PAGEREF _Toc14718 3 HYPERLINK \l _Toc8740 1