盾构机巡检表英文版).docVIP

PAGE 5 11. MAINTENANCE AND INSPECTION The following items are essential to ensure the smooth running of the shield machine. 11-1 Mechanical No. Check Points During operation Once a day Once a week Once a month Once per 3 months Remarks Shield body Any parts abnormal? Any abnormalities in the mounting conditions of each apparatus? Have the welds any cracks or other damage? Any abnormalities in the mounting of thrust jack spreaders? Any earth and sand accumulated around spreaders and on the rods? Clean after every use Any abnormalities in the mount on the scaffold vertical beam? No. Check Points During operation Once a day Once a week Once a month Once per 3 months Remarks Power unite and Hydraulic carriage 1 Any abnormalities in the carriages? 2 Oil tank level acceptable? Check when starting work 3 Any contamination of working fluid? Check by the manufacturer every 6 months. 4 Any abnormalities in the mounting of pumps, motors, or couplings? 5 Is the pump rotating direction normal? 6 Is main pressure setting correct? 7 Is flow adjustable pump working normally? 8 No oil leaks from hoses or pipes? 9 Any dust and dirt stuck in oiling ports? Always check before replenishing 10 Any oil leaks? 11 Any abnormal sounds when pump and motor are running? 30 to 600 C 12 Is air mixed with working fluid discharged from pump? No. Check Points During operation Once a day Once a week Once a month Once per 3 months Remarks Power unite and Hydraulic carriage 13 Is air fully expelled from pump? Air releasing Once/month 14 Clean filters (Check all components of dust once a quarter.) Replace for meshes below 40 mm 15 Any vibration in hoses or pipes? 16 Are the operation of solenoid valves well? 17 Is the working fluid temperature suitable? 30 to 600 C 18 Any abnormalities in the carriage appearance? 19 Is there any deformation in the tie connecting the left and right carriages? Is the connecting bolt firmly tightened? 20 Confirm that the No.1 carriage is on the rail and not derailed. N