停车场控制系统设计.docxVIP

毕业设计（论文） 课题 停车场控制系统设计 停车场控制系统设计 摘要 该作品是将可编程控制器、嵌入版组态软件及单片机配合来实现对停车场的模拟控制。可编程控制器由于其通用性和扩展性好、运用丰富，并且它的体积小、安装灵活、可靠性高、抗干扰能力强，适合在诸多环境条件较恶劣下使用，因此选用该控制器作为主控制器。设计之初，根据设计要求，设计停车场运行程序，再将编好的程序输入PLC中，进行程序的调试和修改，最终确定程序；用组态软件来实现对停车场的监控和控制，在MCGS软件里根据实物画出停车场的模拟图，并设置好相应的动画组态，再进行变量连接，链接后与PLC进行通道连接，最后进入运行环境，即能用组态软件实现对停车场的监视和控制，实现远距离的监控；单片机由于其价格较为便宜，而且由于材料的改革，可以进行多次的改写擦除，因此为了在停车场中更好的使用液晶显示屏对车位数进行计数，采用了单片机编写程序显示。 关键字：可编程控制器、嵌入版组态软件、单片机 Parking control system design Abstract This work is to embed the programmable controller, version of the configuration software and MCU to realize the simulation of parking lot control. Programmable controller because of its versatility and expansibility is good, rich, and its small size, flexible installation, high reliability, strong anti-interference ability, suitable for use under various environmental conditions is bad, so choose the controller as the main controller. At the beginning of the design, according to the design requirements, design of the parking lot to run the program, then make up of PLC input, its best for program debugging and modification, finally determine the program; Using configuration software to realize the monitoring and control of the parking lot, according to the material of the parking lot in the MCGS software simulation diagram, configuration, and set up corresponding animation variables connected again, after the link with PLC channel connection, finally entered the running environment, namely can use configuration software to realize the monitoring and control of the parking lot, realizing remote monitoring; Single chip microcomputer as its price is relatively cheap, but due to the reform of the material, can be repeated rewrite erased, so in order to better use in the parking lot LCD screen to count the amount of parking Spaces, adopted micro controller program show. Key words: PLC，The embedded edition MCGS，Single chip microcomputer 目录 TOC \o 1-3 \h \u HYPERLINK \l _Toc18819 摘要 PAGEREF _Toc18819 1 HYPER